|
|
Post by jmerr86 on Feb 8, 2015 19:27:12 GMT -5
So I just finished pluming up my New Jebao DC 9000 and it wont start up. I have tried un plugging it and both the power supply and the controller are lit up but still no pumping. Any thoughts before I contact the seller. |
|
|
|
Post by maineultraclassic on Feb 8, 2015 19:28:21 GMT -5
Have you rotated the impeller by hand to make sure it's free and not bound up at all.
|
|
|
|
Post by jasonandsarah on Feb 8, 2015 19:32:23 GMT -5
+1^^ I have the same pump and if the screws are to tight the impeller can't turn.
Sent from my SM-N910R4 using proboards
|
|
|
|
Post by jmerr86 on Feb 8, 2015 20:09:03 GMT -5
^
That was it I had glued a bushing in after the adapter was on the pump and a bit of glue has dropped in and was holding the impeller to the case. All better thanks
|
|
