|
|
Post by speedyron on Feb 15, 2014 7:52:28 GMT -5
i will bring my tds meter over today and we can compare cuz u should get a higher reading then that out of Dover water that stuff is nasty
|
|
|
|
Post by doverdoug on Feb 15, 2014 17:51:35 GMT -5
Thanks rondo I knew it should have been higher from the tap. My tds meter is installed so that it reads after the ro and again after the di. I had a reading of 0 after the ro and before the di and thought I should have had more tds inline at that point. Oh well turns out the tds from my tapwater is less than 60 and my brs rodi works great.
|
|
stephen
Full Member
"Slow is Pro"
Posts: 292
|
Post by stephen on Feb 16, 2014 16:00:19 GMT -5
I just got a TDS meter. Let me know if u want help testing TDS
|
|
|
|
Post by jasonandsarah on Feb 16, 2014 17:38:49 GMT -5
You can switch then to where you want to its not a very hard thing to do.
I'm gonna be adding a tds meter to my Ro/DI this week sometime? And a pressure gauge.
|
|
|
|
Post by speedyron on Feb 17, 2014 9:13:30 GMT -5
carfull of the pressure guage they usualy have metal in them. be a shame to expose ur purified water to that and also dont know to what benefit it would serve you. having the tds at end will tell you when filter needs changing tho
|
|
|
|
Post by doverdoug on Feb 17, 2014 14:57:23 GMT -5
My unit says to run it at 50psi minimum but not over 80psi as it will damage the membrane.
|
|
|
|
Post by jasonandsarah on Feb 17, 2014 15:28:06 GMT -5
I believe most Ro/DI ruin best at around 65 psi? I could be way off though lol
|
|
|
|
Post by speedyron on Feb 17, 2014 20:07:52 GMT -5
if your going to run a pressure guage then do it b4 the ro but may as well get a pressure regulator too so you have the ability to do something about it
|
|
|
|
Post by jasonandsarah on Feb 20, 2014 7:11:39 GMT -5
Ball valve is a good pressure regulator:)
I want the pressure gauge so I can run my Ro/Di at the psi that's recommended.
|
|
|
|
Post by jasonandsarah on Feb 20, 2014 7:13:25 GMT -5
Got it in last night and installed it Attachments:
|
|
|
|
Post by speedyron on Feb 20, 2014 8:13:24 GMT -5
ball valve does not regulate presser just reduces flow till it equalizes a lot people dont understand this
|
|
|
|
Post by jasonandsarah on Feb 20, 2014 10:58:18 GMT -5
Fresh on my tds was 45 going into DI chamber after flushing the membrane and waiting a min it's slowly gone down since and is holding steady at 2 and coming out of DI it's at 000!
I have well water! I'm very surprised it's this low
|
|
